Cut the paper to the form of the stone. Thrust it into a pail
of water, knead it about vigorously, roll it into a ball and pummel
it, so as to break the grain and let the water well into it. Then wet
the stone, shake out the paper like a wet handkerchief, full of
creases, lay it on the stone and begin to beat it in with a hard,
long spoke-brush. A few strokes round the edge will catch it down so
that the wind does not disturb it. Then begin to beat it heavily
along the top edge; beat it to a pulp, and patch with strips left
soaking in the water wherever breaks occur. If the stone is porous
the paper may part from it, especially if expanded by beating; the
only course then is to slush more water on the face so that it will
go through the breaks and hold the paper down again. It may be
needful to slit the paper to let the water go below it. Beat down
again, enough to fix it.
(3) For casting purposes a final backing sheet, moderately beaten on,
is needed to hold the squeeze together and stiffen it. Either (2) or
(3) can be left on the face of the stone till quite dry, and then
carefully detached by lifting up from one corner, and slipping a
dinner-knife or a slip of wood under the paper to lift any part that
sticks.
Stiff squeezes as (3) must be packed flat; thin, as (1) and sometimes
(2), may be rolled in a large curve, but this always deteriorates a
squeeze.
Pages:
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41